How to Make Compost Manure

1. Select a location close to where you want to use the compost. The place should be sheltered from the wind, rain, sun and runoff. A compost pile must not get either very dry or very wet.
2. Measure a rectangle 120 cm (4 feet) wide and 150 cm (5 feet) or more long. The length depends on how much composting material you have. Do not make the rectangle wider than 120 cm, as you have to be able to work on the compost without stepping on it. In rainy places, it is best to make the compost pile above the ground. In drier areas, use the pit method described later in this section.
3. Dig a shallow pit about 30 cm (1 foot) deep. Put the soil on one side, you will need it later.
4. Begin building a compost pile by putting a bottom layer of rough materials such as maize stalks and hedge cuttings in the pit. This layer should be about 30 cm thick. Chop up any materials which are too long to improve the air circulation in the pile. Sprinkle some water on this layer.
5. Add a second layer of dry vegetation, hedge cuttings or grass. This layer should be about 15 cm thick (6 inches). Sprinkle water on this layer too. You should sprinkle water on each layer as you add it. The pile should be moist throughout.
6. Put on a third layer of animal manure. The manure contains micro-organisms which are vital for decomposition.
7. Sprinkle some ash or dust on this layer. The ashes contain valuable mineral including potassium, phosphorus, calcium and magnesium. The ashes also neutralise the acids produced during decomposition, especially by the animal manure.
8. The next layer should be green leaves from high-protein leguminous trees like Calliandra, Leucaena and Sesbania. You can also use hedge cuttings of plants like Tithonia.
9. Sprinkle on a little topsoil or old compost. The topsoil contains bacteria which are useful in the decomposition process.
   

   Composting pile method (c) Reproduced from Sustainable Agriculture Extension Manual (IIRR)

    

10. Add more layers in turn, starting with dry vegetative materials, then animal manure or biogas slurry, followed by wood ash, green vegetation and topsoil. Remember to sprinkle water on every layer. Build the pile up to 1.5 m (5 feet) high. A well-made pile has almost vertical sides and a flat top.
11. To complete the pile, cover it all over with a layer of topsoil about 10 cm (4 inches) thick. This layer prevents plant nutrients from escaping from the compost pile. Lastly, cover the whole with dry vegetation such as banana leaves to reduce moisture loss through evaporation.
12. Take a long, sharp, pointed stick and drive it in at an angle so that it passes through the pile from top to bottom. This stick will act as your “thermometer”. After 3 days, decomposition will have started in the pile, and the stick will be warm when you pull it out.
13. Pull the “thermometer-stick” out from time to time to check the progress of the pile. You can also tell from the thermometer how dry or wet the pile is: it should be moist but not wet.
14. Sprinkle water on the pile occasionally (about every 3 days, depending on the weather). If it has been raining, you may not need to water the pile.
15. After 2-3 weeks, turn the pile over. Do not add any fresh materials except water. You must turn the pile if the “thermometer-stick” is cold when you pull it out, or if it has a white substance on it, as this shows that decomposition has stopped. Turning the pile is important because it mixes the different layers, making the decomposition faster and more complete.
16. The compost should be ready after 4 weeks. Check the temperature of the pile to make sure. If the stick feels warm when you pull it out, the pile is still decomposing and the compost is not ready. Finished compost should have a fresh, earthy smell and should contain no grass, leaves, or animal manure.
17. You can store compost by covering it with a layer of banana leaves or polythene.

Well-decomposed compost should be applied at the rate of 20 t/ha (8 t/acre): about two large hoefuls per square metre, or enough to barely cover the ground with a layer 1 cm (0.4 inch) thick.

Composting: Pit method (low rainfall): This method is suitable for low-rainfall areas

The pit method of making compost conserves moisture, so it is useful in areas with low rainfall and a long dry season. Do not use it in wet areas, as the compost may become waterlogged.

1. Dig a pit 1.2 m (4 feet) wide and 0.6 m (2 feet) deep, and as long as you need for the amount of materials you have.
2. Build a pile in the pit, using the same method as in the pile method (see above).
3. Add a layer of wood ash (if available) along with urine and mud.
4. Next spread a 5cm layer of bedding with cattle dung and soil. Sprinkle with water until moist.
5. Continue adding layers until the material is 30 cm above ground level. Apply water. The heap will shrink as it decomposes.
6. Turn over the heap three times. Moisten with water each time. Decomposition needs proper mixing as well as circulation of water and air. You can ensure this by turning over the material three times:

• First turning: 10-15 days after filling the pit
• Second turning: 15 days later
• Third turning: after 2 months.

At the third turning, you can take it out of the pit and put it back in. This helps the bacteria to get nitrogen out of the air.

Article credit: Biovision